Kentix KSS-BASIC-2-B Manual de servicio descargar pdf (Pagina 23)



5.3. MultiSensor-RF

The MultiSensor-RF is configured by the ControlCenter. Updating the device is neither possible nor

necessary.

5.3.1. Kentix system jack - MultiSensor-RF

Via the Kentix system jack, located in the front of the MultiSensor-RF, system components such as leakage

detectors, door contacts, acoustic signals or alarms of USPs or climate devices can be connected. The

MultiSensor-RF is powered via the Kentix system jack.

To connect external devices or alarm in- or outputs, three connector modules are available:

1) Power-Adapter KIO 1: Power supply, 2 digital inputs

2) Power-Adapter KIO 2: Power supply only

3) Power-Adapter KIO 3: Power supply, 2 digital inputs and 2 relay outputs

5.3.2. Adding a MultiSensor-RF

1. For adding a MultiSensor-RF to the AlarmManagers configuration start the teach-in process in the Kentix

ControlCenter and press the „learn button“ for 1 second. The button can be accessed via the hole in the

cases back.

2. The sensor should appear in the list after approx. 15-20 seconds and is configured automatically.

3. The teach-in process is completed when the sensor is marked in the list with a green checkmark.

4. Click on Apply for completion to add the MultiSensor to the devices list.

1 - Internal system voltage (GND)

2 - Alarm output 1 (Open Collector 100mA)

3 - Alarm output 2 (Open Collector 100mA)

4 - Power supply 10-32VDC (+/-)

5 - Power supply 10-32VDC (+/-)

6 - Alarm input 1 (External dry contact, no/nc)

7 - Alarm input 2 (External dry contact, no/nc)

8 - Internal system voltage (5V)



KENTIX system jack

Page  (04-2015, subject to change) kentix.com23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Sin comentarios

Kentix KSS-BASIC-2-B Manual de servicio Pagina 23