Kentix MultiSensor-RACK Manual de servicio descargar pdf (Pagina 24)

MultiSensor-RF

It is not necessary to configure the MultiSensor-RF. Updating it is also not necessary/possible.

For the setup of a MultiSensor-RF follow the steps in the configuration on page 9.

CO gas sensor

Antenna

Push-Out

cable-insertion

Internal terminal strip 8-pole:

8 - GND

7 - Relay ALARM (Open Collector 100mA)

6 - Switching Relay (Open Collector 100mA)

5 - Power supply 10-32VDC (+/-)

4 - power supply 10-32VDC (+/-)

3 - Ext. alarm input (External dry contact)

2 - Ext. sabotage alarm (External dry contact)

1 - GND

LED yellow - Run/Power

LED red! - Constant light: armed

! - Flash light: Alarm trigger

Kentix system jack for Plug´n Play connection,

power supply and external system devices.

Learn Button between PCB and chassis.

IMPORTANT! Operating the learn-button just with

an non conducting, flat object. Otherwise it may

short circuits.

Connector

PIR-Sensor

Adding a MultiSensor-RF

1. For adding a MultiSensor-RF to the AlarmManagers configuration start the teach-in process in the Kentix

ControlCenter and press the „learn button“ for 1 second. The button can be accessed via the hole in the

cases back.

2. The sensor should appear in the list after approx. 15-20 seconds and is configured automatically.

3. The teach-in process is completed when the sensor is marked in the list with a green checkmark.

4. Click on Apply for completion to add the MultiSensor to the devices list.

Page 24 ! ! ! ! (08-2014, subject to change) kentix.de

Kentix Systembuchse

1 - GND

2 - Alarm output (Open Collector 100mA)

3 - Remote switch output (Open Collector 100mA)

4 - Power supply 10-32VDC (+/-)

5 - Power supply 10-32VDC (+/-)

6 - Ext. alarm input (External dry contact, nc/no)

7 - Ext. sabotage alarm (External dry contact, nc/no)

8 - 5V internal system voltage

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 70 71

Comentarios a estos manuales

Sin comentarios

Kentix MultiSensor-RACK Manual de servicio Pagina 24

Comentarios a estos manuales