Kentix MultiSensor-RACK Manual de servicio descargar pdf (Pagina 34)

Opening of the casing / replacement of battery

The board of the MultiSensor-Door / -RACK-MINI is fixed in the lid of the casing which is connected to the

bottom part with two screws. To open the casing remove the two screws on the top and bottom side and pull

the lid away from the bottom part.

Take the battery out of the mounting and replace it with an equivalent type (see data sheet).

NOTE!

The battery level of the MultiSensor-Door can be read out with the ControlCenter. At a low battery level an

alarm is sent via SMS and E-mail to all administrators. In this case replace the battery as soon as possible.

Adding a MultiSensor-Door / -RACK-MINI

1. For adding a MultiSensor-Door / -RACK-MINI to the AlarmManager‘s configuration, start the teach-in

process in the Kentix ControlCenter. Press the „learn button“ and keep it pressed.

Directly after pressing it, a sound is played which is repeated after approx. 5 seconds.

Release the button after the second sound.

2. The sensor should appear in the list after approx. 15-20 seconds and is configured automatically.

3. The teach-in process is completed, when the sensor is marked in the list with a green checkmark.

4. For completion click on Apply to add the MultiSensor-Door to the devices list.

NOTE!

The MultiSensor-Door (battery version) sends its data, depending on the configured energy profile, in a

routine message every 5 or 10 minutes. Note that it can take up to 10 minutes after saving the data to the

AlarmManager, until the sensors measured values appear in the ControlCenter‘s dashboard.

Identifying a MultiSensor-Door / -RACK-MINI

If more than one sensor was added during the teach-in process, it might be necessary to identify the sensors

for configuration.

To identify a sensor open the settings tab „Sensors-Devices“ and right-click on one of the MultiSensor-Door /

-RACK-MINI. In the context menu choose „Identify sensor“.

A search window appears to display an identified sensor.

Now take one of the sensors and briefly press the „learn button“ one time. The sensor makes a short sound

and will appear in the window after a few seconds.

Afterwards the window closes automatically and the sensor is marked in the device list of the ControlCenter

for further configuration.

Repeat this process for all other MultiSensors, if necessary.

Page 34 ! ! ! ! (08-2014, subject to change) kentix.de

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 70 71

Sin comentarios

Kentix MultiSensor-RACK Manual de servicio Pagina 34